Execution Condition

WARNING: This page is about a different variant/trim than selected.

Secondary parameters

Execution condition

Diagnosis 1
12 V battery system voltage

≥ 9 V

Transmission range

Drive or Reverse

Measured primary pulley shaft speed/Measured front output shaft speed

≥ 0.36
and

≤ 2.34

Diagnosis 2
12 V battery system voltage

≥ 9 V

Transmission range

Drive or Reverse

Measured primary pulley shaft speed/Measured output shaft speed ⁽¹⁾

≥ 0.36
and
≤ 2.34

⁽¹⁾	Measured output shaft speed: Measured rear output shaft speed x 0.543 ** + Measured front output shaft speed x (1 - 0.543)

0.543: Center differential gear ratio