DTC P2746: Intermediate Shaft Speed Sensor "B" Circuit Range/Performance: Notes

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

Immediately at fault recognition

Trouble symptom:

Standing start problems
Shock occurs when engaging the lockup clutch.
Shock occurs when selecting shift position.

CHECK DTC.
Read the DTC using Subaru Select Monitor.

Besides DTC P2746, is any of the DTCs P2747, U0100 and U0401 displayed?

Yes: Perform the diagnosis according to DTCs other than P2746.

No: Perform the diagnosis according to DTC P2747. Refer to CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS)>DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)>DTC P2747 INTERMEDIATE SHAFT SPEED SENSOR "B" CIRCUIT NO SIGNAL .