Execution Condition

WARNING: This page is about a different variant/trim than selected.

Secondary parameters

Execution condition

Diagnosis 1
12 V battery system voltage

≥ 10 V

Transmission range

Drive

Measured secondary pulley shaft speed

≥ 100 rpm

Measured output shaft speed ⁽¹⁾

≥ 100 rpm

Commanded forward & reverse clutch pressure control solenoid current

< 0.9 A

Engine speed

≥ 400 rpm

Diagnosis 2
12 V battery system voltage

≥ 10 V

Transmission range

Drive

Measured output shaft speed ⁽¹⁾

< 100 rpm

Commanded forward & reverse clutch pressure control solenoid current

< 0.9 A

Accelerator pedal position (from ECM)

> 6%

Engine speed

≥ 400 rpm

⁽¹⁾	Measured output shaft speed: Measured rear output shaft speed x 0.543 ** + Measured front output shaft speed x (1 - 0.543)

0.543: Center differential gear ratio