Diagnostic Method
WARNING: This page is about a different variant/trim than selected.
If the duration of time while the following conditions are met is longer than the time indicated, judge as NG.
JUDGMENT VALUE SPECIFICATION
| Malfunction Criteria | Threshold Value | ||
|---|---|---|---|
| Diagnosis 1 ABS (1): Measured output shaft speed ** - Measured secondary pulley shaft speed/1.322 |
> Table 1 rpm | ||
| Diagnosis 2 Measured secondary pulley shaft speed |
> 600 rpm | ||
Measured output shaft speed: Measured rear output shaft speed x 0.543 *** + Measured front output shaft speed x (1 - 0.543) 0.543: Center differential gear ratio |
|||
VEHICLE SPEED SPECIFICATION
| Vehicle speed (MPH) | 0 | 13 | 25 | 38 | 50 | 63 | 75 |
| ABS: Measured output shaft speed - Measured primary pulley shaft speed (rpm) | 150 | 100 | 100 | 100 | 100 | 100 | 100 |
| Vehicle speed (MPH) | 88 | 100 | 113 | 125 | 138 | 150 | 159 |
| ABS: Measured output shaft speed - Measured primary pulley shaft speed| (rpm) | 100 | 100 | 100 | 100 | 100 | 100 | 100 |
Time needed for diagnosis: 5 seconds
Malfunction indicator light illumination: Illuminates when malfunction occurs in 2 continuous driving cycles.