LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (Except For STI)) >> Oil Level Switch >> Installation >> When Front Crossmember Has Been Removed

When Front Crossmember Has Been Removed

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil level switch and the clip (A) to the oil pan upper.
    NOTE:
    • Use new O-rings.
    • Apply a coat of engine oil to the O-rings.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

    G09476529Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the connector of oil level switch to the engine wiring harness, and install the clip (A) securing the harness.
    G09476614Courtesy of SUBARU OF AMERICA, INC.
  3. Install the front crossmember. Refer to FRONT SUSPENSION>FRONT CROSS MEMBER>INSTALLATION .
scientia non olet · About LEMON Manuals