LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (Except For STI)) >> Engine Oil Cooler Pipe >> Removal >> Front Engine Oil Cooler Pipe

Front Engine Oil Cooler Pipe

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>COLLECTOR COVER>REMOVAL .
  2. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  3. Drain engine coolant. Refer to COOLING (EXCEPT FOR STI)>ENGINE COOLANT>REPLACEMENT>DRAINING OF ENGINE COOLANT .
  4. Remove the center exhaust pipe. Refer to EXHAUST (EXCEPT FOR STI)>CENTER EXHAUST PIPE>REMOVAL .
  5. Remove the clip (B) which holds the front engine oil cooler hose B (A) and the oil level switch harness from the front engine oil cooler pipe. Remove the bolt which secures the front engine oil cooler pipe to the chain cover.
    G10267318Courtesy of SUBARU OF AMERICA, INC.
  6. Lower the vehicle.
  7. Disconnect the front engine oil cooler hose A from the engine oil cooler.
    G09476564Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the clip (A) holding the engine oil temperature sensor harness from the front engine oil cooler pipe.
  9. Remove the bolt which secures the front engine oil cooler pipe to the chain cover. Remove the front engine oil cooler pipe together with the front engine oil cooler hose A.
    G11576827Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the front engine oil cooler hose A from the front engine oil cooler pipe.
scientia non olet · About LEMON Manuals