LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Mechanical System (Except For STI)) >> Cam Carrier >> Disassembly >> Cam Carrier LH

Cam Carrier LH

WARNING: This page is about a different variant/trim than selected.
  1. Loosen the bolts (front camshaft cap LH, intake center camshaft cap LH, intake rear camshaft cap LH, exhaust center camshaft cap LH and exhaust rear camshaft cap LH) equally, a little at a time in numerical sequence as shown in the figure, and remove each camshaft cap.
    NOTE: Arrange camshaft caps in order so that they can be installed in their original positions.
    G09480454Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the intake camshaft LH and the exhaust camshaft LH from cam carrier LH.
    G09480455Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the filter from cam carrier LH.
    G09480456Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the liquid gasket from cam carrier LH, front camshaft cap LH, intake rear camshaft cap LH and exhaust rear camshaft cap LH.
scientia non olet · About LEMON Manuals