LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Intake System (Induction) And Turbocharger (Except For STI)) >> Oil Catch Tank >> Removal

Oil Catch Tank: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the air intake duct. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>AIR INTAKE DUCT>REMOVAL .
  3. Unlock the blow-by diagnosis connector, and disconnect the PCV hose assembly No. 2 from the PCV hose assembly No. 1.
    G11266560Courtesy of SUBARU OF AMERICA, INC.
  4. Lift up the vehicle.
  5. Remove the under cover. Refer to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>REMOVAL .
  6. Disconnect the turbocharger hose from the oil pipe, and drain the engine oil in the oil catch tank.
    NOTE: Prepare the container for draining of engine oil.
    G09480125Courtesy of SUBARU OF AMERICA, INC.
  7. Remove bolts which secure the oil catch tank to the turbocharger and exhaust stay, and remove the oil catch tank.
    G09480126Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals