Intake Duct No. 1

WARNING: This page is about a different variant/trim than selected.

• Except for Canada

Install the vacuum hose, blow-by diagnosis connector harness and wastegate control solenoid valve to the intake duct No. 1.

NOTE:

Tightening torque:

2.8 N.m (0.3 kgf-m, 2.1 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

• For Canada

Set the connector bracket, and using new set bolts, tighten the bolt until the bolt head is broken (bolt head wrenched off).
NOTE: This operation is required only when replacing the intake duct No. 1.

Courtesy of SUBARU OF AMERICA, INC.
Install the wastegate control solenoid valve and air by-pass pipe to the intake duct No. 1.
NOTE:
- Use new O-rings.
- Check that the wastegate control solenoid valve is securely seated.
Tightening torque:

T1: 2.5 N.m (0.3 kgf-m, 1.8 ft-lb)

T2: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the vacuum hose and blow-by diagnosis connector harness to the intake duct No. 1.

Courtesy of SUBARU OF AMERICA, INC.