LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Intake System (Induction) And Turbocharger (Except For STI)) >> Air Cleaner Case >> Removal

Air Cleaner Case: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Refer to NOTE>NOTE>BATTERY .
  2. Remove the air intake duct. Refer to INTAKE (INDUCTION) (EXCEPT FOR STI)>AIR INTAKE DUCT>REMOVAL .
  3. Remove the clip (A) and clip (B) which secure the engine wiring harness and bulkhead harness to the bracket, and remove the bolt which secures the engine control module (ECM) to the bracket.
    G10266252Courtesy of SUBARU OF AMERICA, INC.
  4. Pull out the engine control module (ECM) from the bracket, and move it to a location that does not interfere operation.
    NOTE: When performing the pulling out operation, pay attention not to apply excessive load to the breather filter portion (a) in order to avoid the damage.
    G10266253Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the clips (3 places) which secure the front mud guard RH to the vehicle.
    G10266523Courtesy of SUBARU OF AMERICA, INC.
  6. Turn over the front mud guard RH, and loosen the clamp which secures the air intake boot to the air cleaner case (rear).
    G10266524Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector (A) from the mass air flow and intake air temperature sensor, and remove the clip (B) from the air cleaner case (rear).
    G10266522Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the air cleaner case (rear) and air cleaner element.
  9. Remove the bolt (A) and nut (B), and remove the air cleaner case (front).
    G10266525Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the air cleaner case bracket from the vehicle.
    G10266526Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals