LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake Lever >> Removal

Parking Brake Lever: Removal

  1. Set the wheel stoppers to tires.
  2. Disconnect the ground cable from battery. Refer to NOTE>NOTE>BATTERY .
    NOTE:
    • For model with battery sensor, disconnect the ground terminal from battery sensor.
    • On CVT models, shift the select lever into "N" before disconnecting the battery ground cable.
    • For the power seat, move the seat to the front-most position before removing the battery ground terminal.
  3. Remove the driver's seat. Refer to SEATS>FRONT SEAT>REMOVAL .
  4. Remove the console box assembly. Refer to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
  5. Remove the bracket - console box.
    G10270050Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the lever assembly - hand brake.
    1. Disconnect the connector (a) of the switch assembly - hand brake.
    2. Remove the adjusting nut (b).
      CAUTION: A self-locking nut is used for the adjusting nut of parking cable. Therefore, replace the self-locking nut with a new one when disassembling.
      G08316005Courtesy of SUBARU OF AMERICA, INC.
    3. Remove the bolt, and then remove the lever assembly - hand brake.
    G10270052Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the inner cable end (a) from the equalizer (b).
    G08316007Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals