LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> Body & Frame >> Seat System - Seats >> Rear Seat >> Installation

Rear Seat: Installation

  1. Install the backrest assembly RH and LH.

    Tightening torque: 

    33 N.m (3.4 kgf-m, 24.3 ft-lb)

    NOTE:
    • After installing the backrest assembly, make sure that each seat belt operates normally.
    • Make sure that they are properly secured on each hook on the vehicle side.
  2. Install the rear seat cushion assembly.
  3. Connect the battery ground terminal.

    Refer to NOTE>NOTE>BATTERY .

scientia non olet · About LEMON Manuals