LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> WRX STI Limited >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Body Integrated Unit >> Removal

Body Integrated Unit: Removal

CAUTION: Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.

    Refer to NOTE>NOTE>BATTERY .

    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the cover assembly - instrument panel LWR driver,

    Refer to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .

  3. Remove the knee airbag module,

    Refer to AIRBAG SYSTEM>KNEE AIRBAG MODULE>REMOVAL

  4. Release the lock and remove the fuse holder.
    G08315475Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the relay & fuse box.
    1. Disconnect the connector.
    2. Remove the bolts and nuts, and remove the relay & fuse box.
      G08315115Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the body integrated unit.
    CAUTION: Be careful to keep water and other foreign materials away from body integrated unit terminals.
    1. Disconnect the connector.
      G13263004Courtesy of SUBARU OF AMERICA, INC.
    2. Release the lock and remove the data link connector bracket.
      G08319284Courtesy of SUBARU OF AMERICA, INC.
    3. Release the claws, and pull out the body integrated unit.
      G08319285Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals