Cooler Thermistor (Sunload Sensor): Installation
- Installation of the automatic light control sensor
- Engage the 2 claws and install the automatic light control sensor.
- Connect the connector.
- Installation of defroster nozzle garnish NO. 1
- Engage the claw and install defroster nozzle garnish NO. 1.
- Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Settings when removing/installing battery terminals (Refer to SETTING PROCEDURES AT PARTS REPLACEMENT AND REMOVAL/INSTALLATION )