Clutch Release Cylinder Assy: Installation

WARNING: This page is about a different variant/trim than selected.

Installation of clutch release cylinder ASSY
1. Install the clutch release cylinder ASSY with the 2 bolts.
Standard value: T=37N.m {377kg.fcm} {27.3ft.lbf}
Connection of master cylinder-to-release cylinder hose
1. Connect the master cylinder-to-release cylinder hose to the clutch release cylinder ASSY with the union bolt through 2 new gaskets.
Standard value: T=18N.m {184kgf.cm} {13.3ft.lbf}
CAUTION:
- When tightening by combining a torque wrench and union nut wrench to extend the whole length, the actual torque will be excessive if tightened until the reading of the torque wrench reaches the specified tightening torque. (Refer to WORKING PRECAUTIONS AND NOTES )
- When restoring the clutch release cylinder ASSY, check that the clutch hose is deflected in the same direction as shown in the figure.
- Install the master cylinder-to-release cylinder hose with the marking facing upward.
Courtesy of SUBARU OF AMERICA, INC.
Filling of clutch fluid (refer to CLUTCH FLUID )
Air bleeding of clutch pipeline (refer to AIR BLEEDING )
Clutch fluid leakage check
Clutch fluid amount check (refer to ON-VEHICLE INSPECTION )