LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (M/T Clutch System) >> Clutch Pedal Switch >> Unit Inspection

Unit Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Check of clutch start switch ASSY
    1. Measure the resistance between terminals when operating the shaft.
    G12587991Courtesy of SUBARU OF AMERICA, INC.

    Resistance 

    Inspection terminals Inspection conditions Standard value
    1 - 2 When shaft is pressed in (ON) Less than 1 Ω
    When shaft is not pressed in (OFF) 10 k Ω or more
  2. Check of clutch switch ASSY
    1. Measure the resistance between terminals when operating the shaft.
    G12587992Courtesy of SUBARU OF AMERICA, INC.

    Resistance 

    Inspection terminals Inspection conditions Standard value
    1 - 2 When shaft is pressed in (ON) Less than 1 Ω
    When shaft is not pressed in (OFF) 10 k Ω or more
scientia non olet · About LEMON Manuals