LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (M/T Clutch System) >> Clutch Master Cylinder Assy >> Removal

Clutch Master Cylinder Assy: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Do not let clutch fluid come into contact with the painted surface. If it is splashed, immediately wash it off with water.
  • Remove the clutch master cylinder ASSY as a unit since the clutch hose bracket may be deformed if the clutch master cylinder to release cylinder hose pipe and master cylinder to release cylinder hose when they are still mounted on the vehicle.
  1. Draining of clutch fluid
  2. Removal of the instrument side panel LH (Refer to REMOVAL , Step 14)
  3. Removal of instrument panel under cover SUB-ASSY No. 1 (Refer to LIGHT CONTROL RHEOSTAT )
  4. Disconnection of master cylinder-to-release cylinder hose (refer to CLUTCH RELEASE CYLINDER ASSY )
    G12587957Courtesy of SUBARU OF AMERICA, INC.
  5. Removal of clutch master cylinder ASSY
    1. Remove the clip from the push rod clevis pin.
    2. Remove the push rod clevis pin and disconnect the clutch master cylinder push rod clevis from the clutch pedal SUB-ASSY.
      G12587958Courtesy of SUBARU OF AMERICA, INC.
    3. Remove 2 nuts to remove the clutch hose bracket, clutch master cylinder ASSY, and seat.
      G12587959Courtesy of SUBARU OF AMERICA, INC.
    4. Secure the clutch master cylinder body through an aluminum plate with a vise.
      CAUTION: Do not vise excessively.
    5. Loosen the clutch master cylinder-to-release cylinder hose pipe nut.
    6. Remove the clip and clutch hose bracket.
    7. Disconnect the clutch master cylinder-to-release cylinder hose pipe from the clutch master cylinder ASSY.
scientia non olet · About LEMON Manuals