LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (M/T Clutch System) >> Clutch Master Cylinder Assy >> Disassembly

Clutch Master Cylinder Assy: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Removal of master cylinder reservoir SUB-ASSY.
    1. Remove the master cylinder reservoir cap.
    2. Secure the clutch master cylinder body through an aluminum plate with a vise.
      CAUTION: Do not vise excessively.
    3. Use a pin punch and hammer to drive out a pin.
    4. Remove the master cylinder reservoir SUB-ASSY from the clutch master cylinder body.
    5. Remove the grommet.
  2. Removal of clutch master cylinder kit
    1. Remove the snap ring.
      G12587960Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the clutch master cylinder push rod clevis, master cylinder piston SUB-ASSY, and compression spring from the clutch master cylinder body.
      CAUTION: Avoid damage to the inner surface of the clutch master cylinder body.
scientia non olet · About LEMON Manuals