Input Shaft ASSY: Inspection
WARNING: This page is about a different variant/trim than selected.
- Check of synchronizer ring No. 2
- Apply manual transmission oil to the cone portion of the 3rd gear, and check the clearance between the synchronizer ring No. 2 and the 3rd gear while pressing the synchronizer ring No. 2 by hand.
Standard value: 0.8 to 1.6 mm {0.0314 to 0.0629 in}
Limit: 0.8 mm {0.0314 in}
CAUTION: Check the entire circumference of the gear.NOTE:- If the value is smaller than the limit, replace the synchronizer ring No. 2 with a new one.
- Be sure to use the recommended product or the substitute product for manual transmission oil. (Refer to MANUAL TRANSMISSION OIL )
- Apply manual transmission oil to the cone portion of the 3rd gear, and check that the synchronizer ring No. 2 does not slip in the circumferential direction while pressing it by hand.NOTE:
- If it slips, replace the synchronizer ring No. 2 with a new one.
- Be sure to use the recommended product or the substitute product for manual transmission oil. (Refer to MANUAL TRANSMISSION OIL )
- Apply manual transmission oil to the cone portion of the 3rd gear, and check the clearance between the synchronizer ring No. 2 and the 3rd gear while pressing the synchronizer ring No. 2 by hand.