Input Shaft ASSY: Disassembly

WARNING: This page is about a different variant/trim than selected.

Courtesy of SUBARU OF AMERICA, INC.

Check of needle roller bearing
1. Install the input shaft to the output shaft, and check the needle roller bearing.
  Criteria: There is no abnormal response, bind, noise, and play.
  
  NOTE: If defective, replace the needle roller bearing with a new one.
Courtesy of SUBARU OF AMERICA, INC.
Radial clearance check
1. Install the input shaft to the output shaft, and check the radial clearance.
  Standard value: 0.029 to 0.072 mm {0.00114 to 0.00283 in}
  
  Limit: 0.072 mm {0.00283 in}
  
  NOTE: If the value exceeds the limit, replace the input shaft, needle roller bearing, and output shaft with new ones.
Courtesy of SUBARU OF AMERICA, INC.
Check of input shaft bearing FR
1. Check the input shaft bearing FR.
  Criteria: There is no abnormal response, bind, noise, and play.
  
  NOTE: If defective, replace the input shaft bearing FR with a new one.
Courtesy of SUBARU OF AMERICA, INC.
Removal of needle roller bearing
1. Remove the needle roller bearing from the input shaft.
Courtesy of SUBARU OF AMERICA, INC.
Removal of synchronizer ring No. 2
1. Remove the synchronizer ring No. 2 from the input shaft.
Courtesy of SUBARU OF AMERICA, INC.

Removal of input shaft bearing FR

Remove the shaft snap ring from the input shaft.

CAUTION:

Courtesy of SUBARU OF AMERICA, INC.

Use the SST to remove the input shaft bearing FR from the input shaft.
SST 899714110

CAUTION: Apply press pressure to the inner race of the input shaft bearing FR to remove the input shaft and the bearing FR.