Input Shaft ASSY: Assembly
WARNING: This page is about a different variant/trim than selected.
- Installation of input shaft bearing FR
- Use the SST to install the input shaft bearing FR to the input shaft.
SST 499277000, 398477703
CAUTION: Press-fit by holding the inner race of the input shaft bearing FR. - Select a shaft snap ring so that the thrust clearance between the input shaft bearing FR and the shaft snap ring is within the standard value.
Standard value: 0 mm {0 in}
Limit: 0.1 mm {0.00394 in}
THICKNESS SPECIFICATION - SHAFT SNAP RING TYPEItem number Thickness mm {in} Identification mark 17005AA460 1.95 {0.07677} 0 17005AA470 2.00 {0.07874} 1 17005AA480 2.05 {0.08070} 2 17005AA490 2.10 {0.08267} 3 17005AA500 2.15 {0.08464} 4 17005AA510 2.20 {0.08661} 5 - Install a new shaft snap ring to the input shaft.
- Use the SST to install the input shaft bearing FR to the input shaft.
- Installation of synchronizer ring No. 2
- Apply manual transmission oil to the synchronizer ring No. 2, and install the synchronizer ring No. 2 to the input shaft.NOTE: Be sure to use the recommended product or the substitute product for manual transmission oil. (Refer to MANUAL TRANSMISSION OIL )
- Apply manual transmission oil to the synchronizer ring No. 2, and install the synchronizer ring No. 2 to the input shaft.
- Installation of needle roller bearing
- Apply manual transmission oil to the needle roller bearing and install the needle roller bearing to the input shaft.NOTE: Be sure to use the recommended product or the substitute product for manual transmission oil. (Refer to MANUAL TRANSMISSION OIL )
- Apply manual transmission oil to the needle roller bearing and install the needle roller bearing to the input shaft.