LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Engine Control System (Diagnostics) (2 Of 3) >> EFI System (FA20) >> DTC P0351: Ignition Coil "A" Primary/Secondary Circuit; DTC P0352: Ignition Coil "B" Primary/Secondary Circuit; DTC P0353: Ignition Coil "C" Primary/Secondary Circuit; DTC P0354: Ignition Coil "D" Primary/Secondary Circuit >> Description of functions >> Test drive

Test drive

Perform test drive to check if the DTC recurs.

  1. Connect the SSM4 to the DLC3.
  2. Turn the ignition switch to ON.
  3. Turn on the SSM4.
  4. Follow the SSM4 on-screen instructions to clear the DTCs. (Refer to CHECKING/CLEARING DTC )
  5. Turn the ignition switch to OFF, and wait for 30 seconds.
  6. Turn the ignition switch to ON.
  7. Turn on the SSM4.
  8. Start the engine.
    NOTE: If the engine cannot be started, crank the engine for 10 seconds or more.
  9. Idle the engine for 20 seconds or more.
  10. Follow the SSM4 on-screen instructions to check the DTC. (Refer to CHECKING/CLEARING DTC )
scientia non olet · About LEMON Manuals