Purge Control Solenoid Valve (FA20): Installation

Courtesy of SUBARU OF AMERICA, INC.

1. Installation of purge control solenoid valve
   1. Connect the joint wire harness connector to the purge control solenoid valve.
   2. Connect the fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 to the purge control solenoid valve.
   3. Connect the ventilation hose No. 2 to the air intake boot. (Transmission A/T)
   4. Connect the vacuum sensor connector. (Transmission A/T)
   5. Connect the purge control solenoid valve connector.
   6. Using the nut, install the purge control solenoid valve.

      Standard value: T=6.4N.m {65kgf.cm} {4.7ft.lbf}

2. Installation of engine cover SUB-ASSY No. 1 (transmission A/T) (Refer to INSTALLATION )