LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Windows >> Glass & Power Window System >> Power Window Regulator Motor ASSY (Installed To The Front Side) >> Removal

Power Window Regulator Motor ASSY (Installed To The Front Side): Removal

NOTE: The following procedure is for LH side. Perform the same procedures both for the LH side and RH side, unless otherwise specified.
  1. Disconnection of the battery ground terminal (Refer to WORKING PRECAUTIONS AND NOTES )
  2. Removal of the door armrest cover LH (Refer to DISASSEMBLY )
  3. Removal of the front door trim board SUB-ASSY LH (Refer to DISASSEMBLY )
  4. Removal of power window regulator master switch ASSY W/front armrest base panel UPR LH (driver's side door) (Refer to DISASSEMBLY )
  5. Removal of power window regulator switch ASSY W/front armrest base panel UPR RH (passenger's side door) (Refer to DISASSEMBLY )
  6. Removal of the front door service hole cover LH (Refer to DISASSEMBLY )
  7. Removal of front door glass SUB-ASSY LH (Refer to DISASSEMBLY )
  8. Removal of the front door frame SUB-ASSY RR LWR LH (Refer to DISASSEMBLY )
  9. Removal of front door window regulator W/motor ASSY (Refer to ASSEMBLY )
  10. Removal of power window regulator motor ASSY LH
    1. Using Torx socket wrench T25, remove the 3 Torx screws, and remove the power window regulator motor ASSY LH from the front door window regulator LH.
      G12594903Courtesy of SUBARU OF AMERICA, INC.