LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) >> Fog Light >> Adjustment

Fog Light: Adjustment

NOTE: The following procedure is for LH side. Perform the same procedures for the RH and LH side.
  1. Preliminary operation for adjusting the fog light beams
    1. Check that the vehicle is parked on a level surface.
    2. Check that no luggage is loaded on the vehicle.
    3. Fill up the fuel tank.
    4. Check that there is the specified amount of oil.
    5. Check that there is the specified amount of coolant.
    6. Adjust the tire pressure to the specified value. (Refer to WHEEL AND TIRE SYSTEM )
    7. Shake the car up and down, and let the suspension settle.
    8. Have 1 person get in the driver's seat.
    9. Start the engine and charge the battery.
  2. Turn over the front mud guard LH. (Refer to FOG LIGHT )
  3. Adjusting the fog light beams
    1. Adjust by turning the aiming screw from below the vehicle.
      G12595270Courtesy of SUBARU OF AMERICA, INC.
      NOTE: Tightening the aiming screw makes the fog light face upward, and loosening it makes the fog light face downward.
  4. Inspection of the fog light beams

    Criteria: They shine within 40 m (131.2 ft).

scientia non olet · About LEMON Manuals