LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System (Rear) >> Rear Brake Flexible Hose >> Removal

Rear Brake Flexible Hose: Removal

NOTE:
  • The following procedure is for LH side.
  • Service the LH side and the RH side using the same procedure.
  • The procedures described below are for the normal type. For the brembo type, perform the same procedures as the normal type.
  1. Removal of rear tire
  2. Draining of brake fluid (Refer to REMOVAL (BREMBO TYPE) )
  3. Removal of rear left flexible hose
    1. Remove the union bolt and 2 gaskets to disconnect the rear left flexible hose from the disk brake cylinder ASSY RR LH.
      G12591131Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the bolt and disconnect the rear left flexible hose from the rear carrier LH.
      G12591173Courtesy of SUBARU OF AMERICA, INC.
    3. Secure the rear left flexible hose with a spanner, and disconnect the brake tube using a flare-nut wrench.
      CAUTION:
      • Do not bend or damage the brake tubes.
      • Do not let foreign matter including dirt and dust enter the connection part of the brake tube.
    4. Remove the clip.
    5. Remove the rear left flexible hose.
      G12591174Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals