LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) >> Brake Pedal (AT Model) >> Installation

Brake Pedal (AT Model): Installation

  1. Installation of brake pedal support ASSY
    1. Temporarily install the brake pedal support ASSY with 2 bolts and 4 nuts.
    2. Tighten 4 nuts.

      Standard value: T=18N.m {184kgf.cm} {13.3ft.lbf} 

    3. Tighten 2 bolts.

      Standard value: T=18N.m {184kgf.cm} {13.3ft.lbf} 

  2. Installation of push rod pin
    1. Apply NIGTIGHT LYW No. 2 or equivalent to the periphery of the push rod pin.
      G12591042Courtesy of SUBARU OF AMERICA, INC.
    2. Insert a new push rod pin from the left side of the vehicle, and connect the push rod clevis to the brake pedal ASSY with a new clip.
  3. Installation of stop light switch mounting adjuster
    1. Engage 2 claws, and install the stop light switch mounting adjuster.
    G08557009Courtesy of SUBARU OF AMERICA, INC.
  4. Brake pedal height check -adjustment (Refer to ADJUSTMENT )
  5. Brake pedal free play check (Refer to BRAKE PEDAL (MT MODEL) )
  6. Brake pedal clearance check (Refer to BRAKE PEDAL (MT MODEL) )
  7. Installation of stop light switch ASSY (Refer to INSTALLATION )
  8. Installation of instrument panel under cover SUB-ASSY No. 1 (Refer to INSTALLATION )
  9. Installation of instrument side panel LH (Refer to INSTALLATION , Step 8)
scientia non olet · About LEMON Manuals