LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System (Hydraulic) >> Brake Pedal (AT Model) >> Assembly

Brake Pedal (AT Model): Assembly

  1. Installation of brake pedal bushings
    1. Install the brake pedal bushings to the brake pedal.
      G12591038Courtesy of SUBARU OF AMERICA, INC.
  2. Installation of brake pedal
    1. Apply NIGTIGHT LYW No. 2 or equivalent to the sides of brake pedal shaft collar and the brake pedal return spring.
      G12591039Courtesy of SUBARU OF AMERICA, INC.
    2. Install the brake pedal return spring and the brake pedal shaft collar to the brake pedal.
    3. Install the brake pedal to the brake pedal support ASSY.
      G12591040Courtesy of SUBARU OF AMERICA, INC.
    4. Install the brake pedal to the brake pedal support ASSY with bolt and nut.
      NOTE: Secure the bolt and tighten the nut.

      Standard value: T=30N.m {306kgf.cm} {22.1ft.lbf} 

      G12591041Courtesy of SUBARU OF AMERICA, INC.
  3. Installation of brake pedal stopper
    1. Install the brake pedal stopper to the brake pedal.
scientia non olet · About LEMON Manuals