Brake Master Cylinder ASSY: Installation
- Installation of seal SUB-ASSY
- Install a new seal SUB-ASSY.
- Installation of brake master cylinder SUB-ASSY
- Install the brake master cylinder SUB-ASSY with 2 nuts.
Standard value: T=13N.m {133kgf.cm} {9.6ft.lbf}
- Using a union nut wrench 12, connect 2 brake tubes to the brake master cylinder SUB-ASSY.
Standard value: T=19N.m {194kgf.cm} {14.0ft.lbf}
- Connect the brake fluid level warning switch connector.
- Install the brake master cylinder SUB-ASSY with 2 nuts.
- Brake fluid refill (Refer to BRAKE FLUID )
- Air bleeding of brake master cylinder SUB-ASSY (Refer to ON-VEHICLE INSPECTION )
- Air bleeding of brake system (Refer to ON-VEHICLE INSPECTION )
- Brake fluid leak check
- Brake fluid level check (Refer to ON-VEHICLE INSPECTION )
- Installation of front upper suspension-to-cowl brace SUB-ASSY RH (Refer to INSTALLATION )
- Installation of front tire LH
Standard value: T=120N.m {1224kgf.cm} {88.5ft.lbf}