LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System (Front) >> Front Brake Flexible Hose >> Removal

Front Brake Flexible Hose: Removal

NOTE:
  • The following procedure is for LH side.
  • Service the LH side and the RH side using the same procedure.
  • The procedures described below are for the normal type. For the brembo type, perform the same procedures as the normal type.
  1. Removal of front tire
  2. Draining of brake fluid
    CAUTION: Do not let brake fluid come into contact with the painted surface. If it happens, wash it out immediately.
  3. Removal of front flexible hose No. 1
    1. Remove the bolt and disconnect the front flexible hose No. 1 from the front shock absorber ASSY.
      G12591124Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the union bolt and 2 gaskets, and then remove the front flexible hose No. 1.
      G12591125Courtesy of SUBARU OF AMERICA, INC.
    3. Secure the flexible hose No. 1 with a spanner, and disconnect the brake tube using a flare-nut wrench.
      CAUTION:
      • Do not bend or damage the brake tubes.
      • Do not let foreign matter including dirt and dust enter the connection part of the brake tube.
    4. Remove the clip.
    5. Remove the front flexible hose No. 1.
      G12591126Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals