LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Roof Drip Side Finish Molding >> Removal

Roof Drip Side Finish Molding: Removal

NOTE: The following procedure is for LH side. Perform the same procedures for the RH and LH side.
  1. Removal of the roof drip side finish molding CTR LH
    1. Release the 2 clips, and remove the roof drip side finish molding CTR LH.
      CAUTION:
      • Do not remove the roof drip side finish molding clip.
      • If the roof drip side finish molding clip is damaged, replace it with a spare roof drip side finish molding clip.
      G12595453Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals