LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Rear Bumper >> Removal

Rear Bumper: Removal

  1. Removal of the trunk floor mat
  2. Removal of the rear floor finish plate (Refer to REMOVAL , Step 2)
  3. Removal of the trunk side tray LH
    1. Using a clip remover, remove the clip.
    2. Remove the trunk side tray LH.
      G08558019Courtesy of SUBARU OF AMERICA, INC.
  4. Removal of the trunk trim cover INN LH (Refer to REMOVAL , Step 3)
  5. Removal of the rear bumper cover
    1. Disconnect the connector of the back-up light ASSY.
    2. Release the clamp, and disconnect the wiring harness.
      G12595393Courtesy of SUBARU OF AMERICA, INC.
    3. Disconnect the grommet, and pull the wiring harness out to the vehicle exterior.
      G12595394Courtesy of SUBARU OF AMERICA, INC.
    4. Remove the 2 screws.
      G08558022Courtesy of SUBARU OF AMERICA, INC.
    5. Apply protective tape around the rear bumper cover.
      G12595396Courtesy of SUBARU OF AMERICA, INC.
    6. Using a clip remover, remove the 6 clips.
      G08558024Courtesy of SUBARU OF AMERICA, INC.
    7. Using a clip remover, remove the clip.
      NOTE: Perform same procedures for the RH side.
      G12595398Courtesy of SUBARU OF AMERICA, INC.
    8. Pull the rear bumper cover towards the exterior, and release the 5 claws.
      NOTE: Perform same procedures for the RH side.
      G11263093Courtesy of SUBARU OF AMERICA, INC.
    9. Pull the rear bumper cover towards the rear, and release the 3 claws.
      NOTE: Perform same procedures for the RH side.
      G08558027Courtesy of SUBARU OF AMERICA, INC.
    10. Remove the 3 guides, and remove the rear bumper cover.
      G12595401Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals