Rear Bumper: Assembly

Installation of the rear bumper bracket CTR (Installed on the LH side)

Install the rear bumper bracket CTR.

Courtesy of SUBARU OF AMERICA, INC.

Installation of the rear bumper bracket CTR (Installed on the RH side)
NOTE: Install the part in the same manner as LH side.

Installation of the rear bumper beam COMPL

Using the 4 bolts and the 2 nuts, install the rear bumper beam COMPL.

Standard value: T=45N.m {459kgf.cm} {33.2ft.lbf}

Courtesy of SUBARU OF AMERICA, INC.

Installation of the rear bumper side bracket LH

Using 3 screws, install the rear bumper side bracket LH.

Courtesy of SUBARU OF AMERICA, INC.

Installation of the rear bumper side bracket RH
NOTE: Install the part in the same manner as LH side.

Installation of the rear bumper side retainer LH

Using 2 screws, install the rear bumper side retainer LH.

Courtesy of SUBARU OF AMERICA, INC.

Installation of the rear bumper side retainer RH
NOTE: Install the part in the same manner as LH side.

Installation of the rear bumper side seal LH

Using 4 clips, install the rear bumper side seal LH.

Courtesy of SUBARU OF AMERICA, INC.

Installation of the rear bumper side seal RH
NOTE: Install the part in the same manner as LH side.

Installation of the rear bumper reinforcement NO. 2 (Installed on the LH side)

Using 2 clips, install the rear bumper reinforcement NO. 2.

Courtesy of SUBARU OF AMERICA, INC.

Installation of the rear bumper reinforcement NO. 1 (Installed on the RH side)
NOTE: Install the part in the same manner as LH side.
Installation of the back-up light ASSY (Refer to INSTALLATION )