LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> BRZ Limited, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Front Door Weather Strip >> Removal

Front Door Weather Strip: Removal

NOTE: The procedures described below are for the RH side. Unless otherwise specified, perform the same procedures for the LH and RH sides.
  1. Fully open the front door glass.
  2. Disconnection of the battery ground terminal (Refer to REMOVAL )
  3. Removal of the door arm rest cover RH (Refer to DISASSEMBLY , Step 2)
  4. Removal of the front door trim board SUB-ASSY RH (Refer to DISASSEMBLY , Step 4)
  5. Removal of the front door glass weather strip ASSY OUT RH
    1. Remove the front door rear cover RH.
      G08558056Courtesy of SUBARU OF AMERICA, INC.
    2. Turn over the rear end of the front door weather strip so that the front glass SUB-ASSY RH can be removed.
    3. Remove the screw.
      G12595450Courtesy of SUBARU OF AMERICA, INC.
    4. Using a flat head screw driver wrapped in protective tape, release the tabs, and remove the front door glass weather strip ASSY OUT RH.
scientia non olet · About LEMON Manuals