LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2019 >> Ascent Limited >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Instrument Panel Lower Cover >> Removal

Instrument Panel Lower Cover: Removal

  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the clips, and remove the cover assembly instrument panel side LH.
    G13201604Courtesy of SUBARU OF AMERICA, INC.
    NOTE:
    • Use a plastic remover.
    • If removing is difficult, remove the weather strip, then remove the part from the gap using a plastic remover.
  3. Release the clips, and remove the ornament panel assembly driver.
    G13201605Courtesy of SUBARU OF AMERICA, INC.
    NOTE: The ornament panel assembly driver can be removed together with the cover LWR driver.
  4. Remove the cover LWR driver.
    CAUTION: When removing the cover LWR driver, be sure to pull it toward you. If attempting to remove by turning it upward, the claws may be damaged.
    G13201606Courtesy of SUBARU OF AMERICA, INC.
    1. Remove the screws and release the clips and claws.
    2. Disconnect each connector and remove the cover LWR driver.
    G13201607Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals