Multi Information Display Switch
- Measure the resistance between connector terminals.
Preparation tool:
Circuit tester
Terminal No. Inspection conditions Standard 3 - 2 Δ (UP) i/SET ↓(DOWN) All OFF Approx. 1 MΩ or more Δ (UP) ON Less than 1 Ω i/SET ON Approx. 1, 000 Ω ↓(DOWN) ON Approx. 3, 700 Ω - Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
Terminal No. Inspection conditions Specification 1 (+) - 4 (-) Apply battery voltage. Light ON - Replace the switch assembly steering (MID) if it is found defective.