Engine Intake System (Induction) And Turbocharger (STI): Intercooler: Installation
- Install the intercooler stay RH No. 1, and install the clip (A) which secures the engine harness to the intercooler stay RH No. 1.
Tightening Torque:
16 N.m (1.6 kgf-m, 11.8 ft-lb)
- Attach the air duct hose to the throttle body.
Tightening Torque:
3 N.m (0.3 kgf-m, 2.2 ft-lb)
- Set the intercooler to the vehicle, and install the bolts securing the intercooler to the intercooler stay RH No. 1.
Tightening Torque:
16 N.m (1.6 kgf-m, 11.8 ft-lb)
- Temporarily tighten the bolt securing the intercooler stay LH to the intake manifold.
- Install the bolts which secure the intercooler to the intercooler stay LH, and install the brake booster vacuum hose to the clip (A).
Tightening Torque:
16 N.m (1.6 kgf-m, 11.8 ft-lb)
- Tighten the bolt securing the intercooler stay LH to the intake manifold.
Tightening Torque:
16 N.m (1.6 kgf-m, 11.8 ft-lb)
- Tighten the clamp (A) which secures the intake duct to the turbocharger.
- Tighten the clamp (B) which secures the air duct hose to the intercooler.
- Install the bolts (C) which secures the air by-pass valve to the intercooler, and install the air by-pass valve.NOTE: Use a new gasket.
Tightening Torque:
T1: 3 N.m (0.3 kgf-m, 2.2 ft-lb)
T2: 16 N.m (1.6 kgf-m, 11.8 ft-lb)
- Connect the PCV hose (B) to PCV pipe assembly.NOTE: Make sure that the leak diagnosis connector is connected securely.
- Connect the connector (A) to the PCV pipe assembly.
- Connect the PCV hoses (A) and (B) to the PCV pipe assembly.NOTE: Make sure that the leak diagnosis connector is connected securely.
- Connect the battery ground terminal.