Driver's Airbag Module: Removal
CAUTION:
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION
- Position the front wheels straight ahead.
- Turn the ignition switch to OFF.
- Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>BATTERYNOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
- Remove the driver's airbag module.
- Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (three locations).
- Disconnect the horn harness and airbag connector, and remove the driver's airbag module. Ref. to AIRBAG SYSTEM>Airbag Connector>PROCEDURE>DRIVER'S AIRBAG MODULE, CURTAIN AIRBAG MODULE AND PRETENSIONER
- Using a hexagon wrench etc. wrapped by protective tape, insert the snap pins and release the locks (three locations).