LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> WRX Premium, Standard Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Instrument Panel Lower Cover >> Removal

Instrument Panel Lower Cover: Removal

  1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. Ref. to NOTE>BATTERY
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the clips, and remove the cover - instrument panel side LH.
    G10271206
    NOTE: Using a plastic remover, open the cover - instrument panel side LH.
  3. Remove the cover assembly - instrument panel LWR driver INN and OUT.
    CAUTION: When removing the cover assembly - instrument panel LWR driver, be sure to pull it toward you. If attempting to remove by turning it upward, the claws may be damaged.
    G10271207
    1. Remove the screws and release the clips and claws.
    2. Disconnect the harness connectors, and remove the cover assembly - instrument panel LWR driver INN and OUT.
      G10271208
scientia non olet · About LEMON Manuals