Multi-Function Display Switch
- Measure the resistance between connector terminals.
Preparation Tool:
Circuit tester
TERMINAL NO. INSPECTION CONDITIONS STANDARD 2 - 3 (UP) Δ
ENTER or VIEW
(DOWN) ↓All OFF Approx. 1 MΩ or more (UP) Δ ON Less than 1 Ω ENTER or VIEW ON Approx. 1, 000 Ω (DOWN) ↓ ON Approx. 3, 670 Ω - Apply Battery Voltage between the connector terminals to check Lighting Condition of Illumination inside the Switch.SWITCH TERMINAL INSPECTION SPECIFICATION
Terminal No. Inspection Conditions Specification 4 (+) - 1 (-) Apply Battery Voltage. Light ON - Replace the Switch - Multi-Function Display if it is found defective.