LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> WRX Limited, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center (Service Information) >> Multi-Function Display (MFD) >> Removal

Multi-Function Display (MFD): Removal

  1. Disconnect the ground cable from battery. Ref. to NOTE>NOTE>BATTERY
    NOTE: For model with battery sensor, disconnect the ground terminal from battery sensor.
  2. Remove the center grille assembly. Ref. to HVAC SYSTEM (HEATER, VENTILATOR AND A/C)>Air Vent Grille>REMOVAL>CENTER GRILLE ASSEMBLY
  3. Release the claw and hook, and then remove the cover center UPR.
    G08316347
    NOTE: Lightly push up the back of the cover center UPR, hook the finger to the end portion and pull it toward you to remove it.
  4. Remove the Multi-Function Display.
    CAUTION: Be careful not to damage the Multi-Function Display or instrument panel.
    1. Release the screws and claws.
    2. Pull the Multi-Function Display assembly toward yourself, and disconnect the connector.
      G08316348
    3. Remove the screws and then remove the Multi-Function Display.
      G12456068
scientia non olet · About LEMON Manuals