Multi-Function Display (MFD): Installation
CAUTION:
- Make sure the electrical connector is connected securely.
- Make sure that the Multi-Function Display operates normally.
- After installing the center grille assembly, check that the air vent grille of the center grille assembly is inserted correctly into the air vent duct.
- When the Multi-Function Display has been replaced, perform the following operations.
- Be sure to reset the ODO fuel economy value of the Multi-Function Display (MFD). Ref. to INSTRUMENTATION/DRIVER INFO>Multi-Function Display (MFD) System>OPERATION>ODO FUEL ECONOMY VALUE RESET
- Be sure to correction the lifetime fuel economy value of the Multi-Function Display (MFD). Ref. to INSTRUMENTATION/DRIVER INFO>Multi-Function Display (MFD) System>OPERATION>DIAGNOSTIC MODE
- Install the Multi-Function Display.
- Install the cover center UPR.
- Install the center grille assembly.
- Connect the battery ground terminal. Ref. to NOTE>NOTE>BATTERY