LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 3.6R Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center >> Switches and Harness >> Installation >> Mid Switch

Mid Switch

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>General Description>CAUTION .
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDC CONTROL MODULE & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
  • Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
  1. Install the MID switch.
  2. Align the center position of the steering roll connector. Ref. to AIRBAG SYSTEM>Roll Connector>ADJUSTMENT .
  3. Install the steering wheel.

    Tightening torque: 

    39 N.m (4 kgf-m, 28.8 ft-lb)

    Clearance: 

    Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)

  4. Install the driver's airbag module. Ref. to AIRBAG SYSTEM>Driver's Airbag Module>INSTALLATION .
  5. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals