Operation procedure A

Connect the Subaru Select Monitor.
On «Start» display, select «Diagnosis».
On «Vehicle selection» display, enter vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Work Support».
From the work support list, select «Read Control module setting information».
Save and close the file.
Replace the combination meter assembly with a new part.
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Work Support».
Select «Write ECU setting save data», and open the file stored in «Read Control module setting information».
When the confirmation screen indicating the vehicle information appears, check that the correct information is displayed and click the «OK» button.
Confirm that «Write operation was completed.» is displayed, and click the «OK» button.