LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 2.5i Touring >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center >> Switches and Harness >> Removal >> Trip Reset Switch

Trip Reset Switch

  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the cover assembly - instrument panel LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
  3. Remove the visor assembly - lower.
    1. Release the clips and claws.
    2. Disconnect the connector and remove the visor assembly - lower.
      CAUTION:
      • Being careful not to damage the visor assembly - lower, slowly remove the clips and claws one by one from the right and left edges of visor assembly - lower.
      • When using a clip remover, wrap it with protective tape or cloth.
      G10272985Courtesy of SUBARU OF AMERICA, INC.
  4. Release the claws, and remove the switch assembly - trip reset.
    G10272779Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals