Operation procedure B

Replace the combination meter assembly with a new part.
Connect the Subaru Select Monitor.
On «Start» display, select «Diagnosis».
On «Vehicle selection» display, enter vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Work Support».
From the work support list, select «Write ECU setting 12 columns of models». Enter the applied model and click the «OK» button. Ref. to IDENTIFICATION>IDENTIFICATION NUMBER & LABEL LOCATIONS .
Enter the option code and click the «OK» button. Ref. to IDENTIFICATION>IDENTIFICATION NUMBER & LABEL LOCATIONS .
Confirm the vehicle information on «Write ECU setting 12 columns of models» display and click the «OK» button.
When «Write?» is shown on the screen, click the «Yes» button.
Confirm that «Write operation was completed.» is displayed, and click the «OK» button.