LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 2.5i Premium >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center >> Combination Meter System >> Operation >> Self-Diagnosis Display Mode >> Meter pointer indication check

Meter pointer indication check

In meter pointer indication check, the meter operation, warning/indicator light and fuel level warning light are checked.

NOTE: ILL indication illuminates at the same brightness as immediately before entering "Meter pointer indication check".
  1. Press the trip reset switch.
  2. After a buzzer sounds for 0.5 seconds and "STEP2" is displayed on TFT, the meter pointer indication check mode is initiated.
    Time
    (sec)    		 Speedometer
    (km/h)    		 Tachometer
    (r/min)    		 Fuel gauge Engine coolant temperature gauge Fuel level warning light Warning/indicator light
    1.5 0 0 Lowest point Lowest point Light ON Fuel level warning light (around E) illuminates. *
    1.5 40 1, 000 E C Light ON
    1.5 100 4, 000 1/2 Starting point of the red line Light OFF
    1.5 140 8, 000 F H Light OFF
    1.5 100 4, 000 1/2 Starting point of the red line Light OFF
    1.5 40 1, 000 E C Light ON

    * : Warning lights and indicator lights controlled by other module are turned on/off according to the module control. Ref. to INSTRUMENTATION/DRIVER INFO>General Description>SPECIFICATION .

scientia non olet · About LEMON Manuals