LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2018 >> Outback 2.5i Limited >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Instrument Panel Lower Cover >> Removal

Instrument Panel Lower Cover: Removal

  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the clips, and remove the cover - instrument panel side LH.
    CAUTION: When removing with a tool, use a plastic remover so that no scratches occur.
    G10273123Courtesy of SUBARU OF AMERICA, INC.
    NOTE: Remove the weather strip - body side flange to facilitate the work.
  3. Remove the data link connector and release the hook, and then remove the under cover assembly - driver.
    G10273124Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the cover assembly - instrument panel LWR driver.
    CAUTION: When removing the cover assembly - instrument panel LWR driver, be sure to pull it toward you. If attempting to remove by turning it upward, the claws may be damaged.
    G10273125Courtesy of SUBARU OF AMERICA, INC.
    1. Remove the screws and release the clips and claws.
    2. Disconnect the harness connectors, and remove the cover assembly - instrument panel LWR driver.
      G10273126Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals