LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2017 >> WRX STI Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center (Service Information) >> Steering Switch >> Installation

Steering Switch: Installation

CAUTION:
  • Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to CAUTION , General Description.
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  • Make sure that the steering roll connector is not turned from the original position.
  • If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VDC SENSOR MIDPOINT SETTING MODE , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
  • Securely install the switch. Improper insertion of the pin or claw of the switch may cause improper installation.
  1. Install the MID switch. Ref. to ASSEMBLY , Steering Wheel.
  2. Align the center position of the steering roll connector. Ref. to ADJUSTMENT , Roll Connector.
  3. Install the steering wheel.

    Tightening torque: 

    39 N.m (4 kgf-m, 28.8 ft-lb) 

    Clearance: 

    Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in) 

  4. Install the driver's airbag module. Ref. to INSTALLATION , Driver's Airbag Module.
  5. Connect the battery ground terminal. Ref. to BATTERY .
scientia non olet · About LEMON Manuals