Combination Meter

On «Start» display, select «Diagnosis».
On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
On «Main Menu» display, select «Each System».
On «Select System» display, select «Combination Meter» and then select «Enter».
On «Select Function» display, select «Active Test».
On «Active Test» display, select an item to be checked.
NOTE:
- For detailed operation procedures, refer to "Application help".
- If not equipped (depending on destination area or vehicle equipment condition), process will not go on.
CAUTION: After executing the system operation check mode, execute the Clear Memory Mode. <Ref. to OPERATION , Clear Memory Mode.>